29-05-2007, 12:10 PM
Protected on the inside by a single strand of Kevlar and on the outside by a transluscent casing of 100% silicone is an ultralow resistance Aramid fiber core. (Maximum voltage of 60,000 volts and ultra low resistance of 5.6k Ohms/m.)
The Ferro Magnetic layer is wound with stainless steel spiral windings to suppress HT spark emissions from interfering with sensitive electronics.
Temperature range: -40 to +220C.
In good condition except one lead where the rubber at the very bottom has a small split in it, i never did anything about it as its bast the weather seal so not a problem but could be glued.. to be honest i didnt notice for 6 months !
As seen here (their darker blue in real life):
Picture of the tear in one..
Like i say the seal is at the top so i have never worried about it
Cost me £50 new..
Id like £20
Tom
The Ferro Magnetic layer is wound with stainless steel spiral windings to suppress HT spark emissions from interfering with sensitive electronics.
Temperature range: -40 to +220C.
In good condition except one lead where the rubber at the very bottom has a small split in it, i never did anything about it as its bast the weather seal so not a problem but could be glued.. to be honest i didnt notice for 6 months !
As seen here (their darker blue in real life):
Picture of the tear in one..
Like i say the seal is at the top so i have never worried about it
Cost me £50 new..
Id like £20
Tom
