what about a filter or you just gonna stick with a panel one, and once thats all sprayed up under the bonnet it will look awesome.
keep an eye out for some cheap spax adjustables for novas as they fit on yours and would completley change the car.
Think im just gonna get a panel filter. I was a carbon enclosed filter but the BMC one is £130
As for coilovers, i need so before the MOT in November so im on the look out
it dont have to be coilovers mate, have a look for nova gte/gsi adjustables with 60mm springs less than half the price and just as good, trust me on this as i think alanman knows what im on about.
Now have my seats and harnesses
Just need to figure out how to fit them
You'll need subframes made for the seats and the car for a simple installation. Otherwise get the welder out.
I no, only problem is the omp subframes are £100!
If i can think im just gonna mount the cobra sidemounts to the floor. At the moment the other problem i have is where to fit the harnesses too. Ive got 2 of the 3 mounting points bud cant get to the other 1
they 3 pointsor 4 ? I'll have a look if your at football tonight
You only need one belt, tell your passenger to use bungee ties.
wont they fit on your rear seat belt mounts at the top of your rear quarter panel with 1 bolt.
They fit on the rear belt mount, seat belt mount next to the door, but on the side of the transmission side there is no mount. There is the mount where the seat belt click think is, but its very hard to get to.
Should be getting the sidemounts for my seats off Matty today, so will see about fitting them.
Took a seat out this morning. Not looking good.
Looks like im gonna have to spank £100 on some omp subframes.
NOT HAPPY!!!!!!!
jus get a welder out and weld them to your normal subframes.
it wont work...
will sit WAY too high up, head near the roof
just get them bought coper then its donr properly first time !
That would not be a problem for me, as im small, and dont like how low they sit anyway. The only thing i can think of is, on the normal seats they are side mounted. Where they bolted on will be in the right place if i bent that bit down.
Anyway a couple of pics
