Maxxd.com Forums

ive go ta 1992 rev 2 mr2 turbo and the apexi power fc ecu's require some sensors changing or something to make it work, does anybody know what i need and were i can get them from? cheers

Not a clue, always thought the power fc was a direct replacement for the factory ECU and that it used all factory sensors??

it is a direct replacement for the rev 3 but i dont think they do them for the rev 2 and i was told that i could still buy that one and then update the wiring loom or something, but i just wanted to know exactly what i needed to do this.

You need to change the air flow sensor as the rev 1 had a massive metal one (the one attached to your air filter).

I'm going down a diffrent route just hope it pays off

btw i have some brand new forge pistons for sale

86.5mm 9.0.0.1 wiseco

And also bearings that are brand new. (i had to go bigger)

mines a rev 2, and what do i need to change it to? a rev 3 one?

Yea you need a rev 3 one as there diffrent.

info here
http://www.imoc.co.uk/forums/viewtopic.p...low+sensor

cheers pal